Searched for "*".

1. Subsequent heat treatment (tempering) of certain elastomers whereby optimal characteristics do not emerge until the associated final linking occurs. 2. Unwelcome additional linking under the influe

needed if a pulling load is present at a hydraulic motor in an open circuit. Since what had been the pressure line then becomes the suction line, the servo-suction valve is intended to prevent a vacuu

Hydraulic valve which creates the difference between the setpoint and actual value and also releases a flow rate proportional to the difference. To this end, the control unit for the valve is connecte

"Torque at the cylinder"; classification characteristic based on drive kinematics for axial piston swashplate (axial piston) pump or motors whereby torque is transmitted to the cylinder drum via the p

Test method for determining the filtration efficiency in general ( retention rate, filtering grade ). This involves passing a specific mineral oil contaminated with quartz sand ( Air Cleaner Fine Test

Arrangement whereby a greater number of pipes for hydraulics, pneumatics and/or electrics can be connected or disconnected in one go ( Figure M 31 ). It must be set up in a way that allows a high numb

Valve combining several functions (e.g. flow + pressure or direction + flow + pressure). Example: flow control valve or continuously adjustable valves where the size of the flow or pressure is recorde

16-bit industrial fieldbus from Intel.

Stroking of hydrostatic machines

Relationship between changes in torque at the motor shaft and changes in the angle of rotation ( load stiffness ).