Hakuteksti "*".

Reflects the workflow of a drive element (e.g. rapid movement –– feed –– reflux of a feed cylinder). It consists of functional lines for individual movements in connection with drive and signal elemen

Devices that close or open electrical contacts in the event of pressure load (DIN ISO 1219-1). They are generally used if an electrical switching command or status signal should be issued when a set (

Flow resistor () with laminar flow, e.g. capillary gap. Has a largely linear flow rate pressure characteristic .

Metal block, which houses several valves through incorporation or addition. The connections necessary for it to function are drilled into the block and are connected to the corresponding lines.

Hydraulic resistance control for an actuator with two type A hydraulic half bridges. For example, the control of a hydraulic cylinder with a dual effect with a continuously adjustable directional valv

Resistance of a liquid to changes in viscosity under shear stress (CETOP RP 100).

Factors (boundary conditions) that affect the operational sequence and the function of systems and devices. These include the load curve, behaviour, installation conditions, operating conditions etc.

Piloted valves

Counting-only measuring system in which first a reference point must be moved to such that a specific position can be determined by counting increments forward or backward (Figure D 29) . The position

That part of a lip seal that generates the preload during installation (Figure D 13) . On compact seals the sealing lip is often shortened to form a sealing edge.