Hakuteksti "*".

Cleanliness level

Check valve that can also be opened against the locking direction if required. This action occurs via a control piston (K 2) that is dimensioned so that it can open the valve cone against the system p

To make elastic seals actually seal they are deformed on installation such that radial forces, the so-called preload , are produced that make it impossible for the hydraulic fluid to flow around the s

In a predetermined valve this is a factor of the size of the flow: the smaller it is, the greater the deviation from the desired value. ( Figure T 6 ). Flow dividers based on displacement units (e.g.

Collective term for the area of electronic processing and control technology that operates with digital signals with the characteristic that the numerical input signals in turn correspond to numerical

The closed end of a cylinder . It can house the rear end position damping and/ or the mounting of the cylinder.

Valves with a large nominal width (generally greater than the nominal size 16 or sometimes at nominal size 10 or nominal size 6) and therefore with large actuation forces are pilot-controlled by a sma

Used to directly influence a subsystem ( controlled subsystem , control subsystem). It adjusts the as long as it is mechanically actuated (DIN 19 226). Example: Electric motor, solenoid, hydraulic set

Often, the entire is labelled as the controller. In a more narrow sense, this is only understood as the computing element (device, program ) within the which continuously compares the control variable

Refers to the physical and mechanical process for recording a measured variable. Example: pressure measurement using a pressure gauge , , piezoresistive or analogue or digital measuring procedure or d