Hakuteksti "*".

Rotary joint for the flow of hydraulic fluid between a stationary and rotating part of the machine. Multiway rotary transfer joints : Rotary transfer joints for supplying one or more loads with pressu

The actuating force acts directly on the function element of the valve, i.e. on directional valves : The control spool is actuated directly by hand, by pressure or by a solenoid ; pressure valves : Th

Filter whose task is to filter out oil droplets from compressed air. They are installed in the compressor group behind the recooler and contain a specific filter element ( Figure O 3 ).

Minimum current needed to flow in an electrical load circuit (e.g. in a solenoid or another electro-mechanical signal converter) in order for a valve to be held in the closed position by the electro-m

Throttle valve with adjustable throttle ( measuring throttle , A P), in which the flow remains constant through the combination of the valve with a control throttle (, A R), regardless of the changing

Also called the real dirt holding capacity. This provides information on the quantity of dirt that a certain filter can hold before a reference pressure (normally the response pressure of the bypass v

Basic design for a hydraulic drive in which the pump draws in the hydraulic fluid from a storage tank, the surface of which is open to atmospheric pressure. The oil is conveyed to the consumer via dir

Design category for seals with a block-like body and a less pronounced sealing edge. A characteristic feature is how the preload is applied not only by the sealing lips , but also by the body of the s

Flow rate that a pump delivers. The term delivery flow should as far as possible no longer be used in fluid technology, instead flow rate should be used.

Centralised hydraulic oil supply .