Hakuteksti "*".

High pass filter assembly that measures the pressure oscillations in the drive and controls the downstream damping devices . This assembly can operate mechano-hydraulically (e.g. hydraulic accumulator

Characterises the chemical composition as well as the physical state of a new hydraulic fluid . Here is must be noted that even new oil is never absolutely clean, instead on average it corresponds to

Feedback of the pressure for the purpose of stabilising a . In general this feedback operates as a secondary loop.

Circuit that routes the outlet flow on the piston rod side on a differential cylinder to the inlet on the piston side to increase the flow velocity ( rapid traverse circuit ) (Figure 22) . As a conseq

Each of the characters from a character set of two characters. Any character can be used as a binary character, e.g. O and L, Yes and No etc. (EDIN 44 300 Part 2).

1. Sum of all measures that are necessary to ensure the safety of the operator as well as the machine against overload. Here the requirements from the responsible authorities have priority; these prim

Measure for the effectiveness of a filter. The value is a ratio that is defined by the number of particles before and after passing through the filter with a specific pressure drop (Figure B 13) : The

Gas (air) volume above the maximum fluid level in a vessel that is intended to absorb the expansion in the volume as the temperature of the fluid changes (CETOP RP 100).

Control of a vehicle with hydrostatic drive by operating the pump as a function of the accelerator pedal for the combustion engine and therefore its rotation speed. Pulling away is therefore gentle an

Position of the moving parts in a device at which the intended switching program starts under the action of the actuating forces. It is achieved via the starting prerequisites (CETOP RP 100).