Hakuteksti "*".

A device installed in the pipe to a pressure gauge which separates the pressure gauge from the pressure associated with the medium as soon as this exceeds a specified limit.

See test conditions

Lock, which primarily serves to protect humans and/or machines. It is normally placed in the individual control level or on the .

Time span that starts when the value for the controlled variable after a step in the disturbance variable or the reference variable leaves a pre-defined tolerance range and that ends when it enters th

The positive displacement principle states that the space required to generate a flow rate during a function period is geometrically reduced (pressure period) and increased again (suction period). The

Depending on the requirements in terms of accuracy, servo cylinders ( Figure S 53 ) are used with two construction designs, which differ in terms of the bearing of the piston and piston rod: 1st cylin

Flow rate of a pump

The limit load control has the task of making it possible to fully exploit the power from a drive motor, even if additional loads are activated and the sum of the power demanded by all loads would exc

Cylinder , in which the lid and bottom are connected to the cylinder tube by a tension rod (Figure Z 7). The tie-rod cylinder is cost-effective. It is used in hydraulic systems at low pressures.