Ricerca di "*".

Collective term for hydraulic cylinders and hydraulic motors . Given the low losses associated with the drive, both have very low levels of damping (D H = 0.05 to 0.2).

Workflow control whose switching conditions depend only on time. For example, timer elements, time counters, gear shift drums with a constant rotation speed can be used to produce the switching condit

Covers the activities associated with devising, coding and testing a computer program (EDIN 19 226, Part 5). In a narrower sense therefore, the word describes the creation of a detailed algorithm in a

Here, the associated force is fed back to acknowledge that a state has been achieved. Force feedback generally uses mechanical means with the help of springs. Example: mechanical feedback from servo v

If the alignment of the output variables to the input variables in a transfer element is described by a system of differential equations or differential equations and standard equations, by introducin

Fitting , which forms an angle of normally 90° between the connection openings. It is offered as a pipe or screw-in fitting ( pipe screw connections ).

The number of binary signals transferred over a data channel per unit of time (DIN 19 226 Part 5). At a cycle frequency of 1 kHz, in the case of series data transmission, this results in a transfer of

Collective term for pumps and devices, which work according to the hydrodynamic principle, i.e. in which the velocity element of the flowing fluid is decisive. For pumps, these are the centrifugal pum

The smallest independent unit of a program, which illustrates the work instruction.

Property of an elastomer seal to become squeezed behind the seal under the influence of pressure in the sliding gap, causing damage to the seal ( Figure S 65 ). Remedy: Another material back ring made