Ricerca di "*".

If the operating conditions during direct actuation become too unfavourable (e.g. due to excessive pressure , excessive flow rate ), indirect actuation will be chosen, which generally uses a smaller d

Hydraulic accumulator on which a spring is used for the pressure load. This solution is only suitable for very small accumulators, as otherwise the spring and therefore the overall dimensions will be

Pressure at the point at which the flushing current leaves the flushed circuit ( feed circuit ) (DIN 24 312).

Hydraulic accumulator manufactured from a combination of steel and plastic to save weight. Suitable for use in vehicles, particularly with a view to energy recovery through braking.

Range in which the "pressure" output signal at a given inlet pressure is controlled by a continuously adjustable valve (E DIN 24 311).

Flow division

In general : The time between the input signal and the increase of the output signal to a given value, measured under certain conditions. Of a signal element : Time which passes after reaching a certa

Semiconductor memory

Electromagnetic position encoder based on the principle of the rotating field that contains a rotor and a stator with a number of windings and with an output voltage that corresponds to the angular po

Mineral oils that are able to partially emulsify any water or to hold it in suspension until it evaporates with increasing temperature. Larger amounts of water (above approx. 2 %) are, on the other ha