Ricerca di "*".

Input signal (correction signal) for bringing a valve to hydraulic zero (DIN 24 311).

Conditions applying at a given moment in time (CETOP RP 100).

Pressure gauge selection switches are used to connect various pressure measuring points to a pressure gauge, assuming this is the preferred option. The pressure gauge may be installed in either the se

The linearity error corresponds to the maximum difference in gradient or the maximum deviation between the target characteristic curve (straight lines) and the actual characteristic curve for the meas

The lifetime is the period during which a device or system is expected to remain functional as expressed by the number of achievable or achieved actuations under certain specified conditions.

Refers to a configuration whereby the output variable (e.g. velocity) is dependent on the load. Example: electric motor in series connection, power-controlled pump, compressed air cylinder (connection

Creation of feedback control and general control systems from ready-made program modules.

"Closed circuit". As the English term "Control" applies to both open loop control and , closed loop normally refers feedback control. Opposite: open loop

Derived from the natural frequency f o as follows: ω o = 2 π · f o

Pressure that is present at a specific point at a specific time (DIN 24 312).