Ricerca di "*".

The displacement units in a hydrostatic displacement machine (vane, piston) are supported on an outer raceway that at the same time defines the stroke of the displacement unit due to the eccentric mou

Position measuring procedure in which the electrical output is changed continuously and in relation to the change in the position. Today many position measuring procedures are analogue. These include,

Controller concepts

The heat emission PD of a reservoir is calculated from the temperature difference between the reservoir and the ambiance (To – Ta), form the heat-emitting area A of the reservoir and the heat transfer

Fluid level height above an inlet or outlet opening. In the case of a negative inlet height, the suction pressure for pumps is lower than the ambient pressure (Figure Z 8).

Valves with two controlled ports: inlet and outlet. Examples: 2/2-way directional valves, 2-way flow control valve, amongst others

Hydro-mechanical signal converter.

Entirety of all functional units to supply the technical control and feedback control devices with energy. The term supply can be more clearly specified by adding supplementary terms as a prefix accor

Pressure, which arises under the influence of a transmission ratio before the smaller area A 2. It is Ratio of piston areas α α greater than the pressure p 1 acting on the larger area A 1 by the ratio

The transport movement of a cylinder is characterised by the force/time curve and the position/time curve. Normally, the largest force to be applied by the cylinder occurs when the load is being accel