Hakuteksti "P - R2 - 1 - 1/4 - AT".

of the welding-neck flanges. The valves type F25 - F80 are available with hydraulic release. Hydraulic release suppresses relief surges that can occur at high pressure and with a large consumer volume.

HRP is available with hydraulic release. Hydraulic release suppresses relief surges that can occur at high pressure and with a large consumer volume.

level of safety in the event of pressure peaks. It features reproducibly accurate and secure closing at the pre-set trigger flow rate. Higher flow rates cause a plate raised from the valve seat by a spring

the highest degree of safety: an emergency valve, which enables the window to be opened and closed at any time. Thanks to a hydraulic accumulator, the window can be independently opened and closed even

automatic lathes. It regulates the clamping pressure and monitors it. The clamping pressure is adjusted at the downstream pressure switch using a manual, mechanical or electrically-proportional adjustment device

stored hydraulic energy. This allows high dynamism with considerable energy savings and shorter cycles. At the same time, the individually adjusted rotation speed substantially reduces the press brake’s drive

The pressure reducing valve type CDK is a screw-in valve, and can be used in control blocks. The bore-holes required for mounting are easy to create. All versions oil-tight when closed.

The type RSV additionally contains a check valve.

The check valve type RK, RB, RC and RE can be screwed-in, type ER can be plugged-in. The spring-loaded ball check valve type RK, RB and ER is very robust and insensitive to soiling. Type ER can be

The compact hydraulic power pack type INKA consists of the tank, the integrated motor and the radial piston pump or gear pump directly attached to the motor shaft. The directly mounted electronic comm