Fixed displacement motor
motor with constant displacement . Its variable rotation speed is determined solely by the (variable) pump or an upstream flow valve.
Transmission efficiency
On hydrostatic transmissions the transmission efficiency comprises the total efficiency of the pump and motor: From here the total power loss is obtained:
Speed ratio
The speed ratio of a hydrostatic transmission is defined by the ratio of the pump speed n 1 to the motor speed n 2:
Delivery flow
Flow rate that a pump delivers. The term delivery flow should as far as possible no longer be used in fluid technology, instead flow rate should be used.
Electromechanical displacement control of pumps/ motors
Actuation of the adjustment equipment in a pump/ motor by an electric motor. Permits in general adjustment speeds that are not very high. Mostly slower than electro-hydraulic adjustment.
Open circuit
Basic design for a hydraulic drive in which the pump draws in the hydraulic fluid from a storage tank, the surface of which is open to atmospheric pressure. The oil is conveyed to the consumer via directional [...] work is performed, is fed back to the tank. It is not possible to reverse the direction in terms of pump delivery. Excessive negative pressure in the suction line should be avoided. A reversal of direction
Pressure filter
Filter that is built into the high-pressure line, i.e. after the pump. It is an advantage that only the pump delivery flow must pass through it and that the following components are protected (Figure D
Primary control
c transmission , the pump can be adjusted and the motor is associated with constant displacement . The drive rotation speed is therefore proportional to the flow rate for the pump, i.e. the adjusted d
MZ engine (swashplate machine)
classification characteristic based on drive kinematics for axial piston swashplate (axial piston) pump or motors whereby torque is transmitted to the cylinder drum via the pistons.
Limit load control
(engine loading), which results in a reduction in the variable pressure at the pump adjustment and therefore causes the pump to pivot back. [...] machinery, i.e. the movement velocity of the machine (corresponds to the flow rate to the variable pump ) is reduced automatically to the advantage of the other drives if the combustion engine would otherwise