Buscado por "with".

the block into which the valve internals are screwed (e.g. on directional valves the valve sleeve with the valve control spool and the actuation) (Figure E 9) .

actuate a valve . The control force reaches its maximum value at the full input signal and is zero with zero input signal. Here there is a device-specific dependency for the output variable, e.g. the flow

switching conditions depend only on time. For example, timer elements, time counters, gear shift drums with a constant rotation speed can be used to produce the switching conditions. The term timing control

Short term for hydraulic oils with additives designed to provide protection against ageing, corrosion and wear. Used where increased wear is expected, as may be the case when high levels of pressure are

sealing surface and the compressive force are working in the same direction. The friction is higher than with a pulling load ( Figure S 83 ).

friction losses, when the cylinder is operating at nominal pressure . As far as single-acting cylinders with spring return are concerned, the value for the start and end of the stroke must be specified.

cylinders, for which there is no more pump for rapid traverse . The pre-charge container is refilled with the reflux oil after each stroke ( Figure V 38 ).

Coefficient of a linear differential equation that describes the transfer function of a system with the parameters damped natural frequency and damping D as the result. d is determined from the measurement

the device (drive). A high power density thus means that large amounts of power can be transferred with relatively small components.

Entirety of all functional units to supply the technical control and feedback control devices with energy. The term supply can be more clearly specified by adding supplementary terms as a prefix according