Buscado por "with".

pressure range in hydraulics is referred to as the medium pressure range , although this is associated with higher pressure levels.

Hydrostatic transmission involving a pump combined with a motor in a block design. In general, stationary forms of hydrostatic transmission are designed as an integral hydrostatic transmission whereby

Covers the activities associated with devising, coding and testing a computer program (EDIN 19 226, Part 5). In a narrower sense therefore, the word describes the creation of a detailed algorithm in a

Functional element, which converts a low-voltage signal into a signal with a higher power. That applies both to the power section and the signal processing, where a voltage signal is converted into a current

variable into a discrete representation. In general, therefore, this means quantising an amplitude, with the amplitude area divided into smaller subsections. The process is known as digitalisation and uses

With proportional spool valves, the overlap/underlap at the individual control edges of the valve (overlap/underlap conditions) determine the flow rate signal characteristic curve ( Figure N 6 ) and the

definition of a dangerous error in a control can only be derived from the interaction of the control with the device to be controlled. Here both active errors (e.g. unintended placing in operation) and also [...] long as both circuits work, the failure is not noticed, however if one circuit fails the other fails with it.

be equipped with control units which work by bits or by words (EDIN 19 226 T 5). In contrast to the hard-wire programmed control, the PLC has application-independent standard hardware with application

bar/s and defines, e.g. on pumps, the amplitude of the pressure pulsation-induced oscillations and with it also the amount of noise.

Hydraulic pump/motor with two or more gears working together in one housing. They may take the form of an external geared pump/motor , an internal geared pump/motor or an annular gear pump/motor .