Buscado por "with".

Measuring arrangement, in which a sensor is integrated in a device with a standard electrical with zero and end point comparison elements, which can be adjusted externally and issues a standard output

temperature resistance from –270° to +260° C. PTFE is used in seals with an elastomer core and in the case of sliding rings and guide rings with filler materials. PA (polyamide, e.g. nylon) has good sliding [...] absorption (swelling). POM (polyacetal, e.g. Delrin) has high mechanical strength, result in parts with a high degree of dimensional accuracy. Material commonly used for back rings, guide rings and scraper

value is referred to as the buckling force F K. Cylinders with a large stroke and/or a thin piston road should undergo further calculations with regard to possible buckling. Euler's formula applies in this [...] horizontal cylinders or those tilted at a considerable angle, since the bending stress associated with the component's own weight is added to the compressive stress in such cases (Figure K 13) .

made between ( Figure S 41 ): The most simple construction type, which requires the most space, works with toothed rack pistons, which enter into a transversally mounted sprocket ( a ). This construction type [...] motors has the pistons arranged in an axial direction and transfers the torque over steep threads with different designs ( b ). Suitable for pivoting ranges of up to 360°. Rotor swivel motors generate [...] rotating wing to allow hydraulic fluid , which is connected to the drive shaft ( c ). Very compact design with a pivoting angle range up to approximately 310° (in the case of two rotating wings: approx. 110°)

the permissible final pressure difference is reached at the rated flow rate QN: γ = contamination with ACFTD in the flow rate, Q = flow rate through the filter, τ = test time until the permissible final [...] dirt holding capacity". It is used to compare the service life of filter elements of the same size with the same β value. The α values is a calculated variable that does not take into account if the filter [...] performance the numerical value for α is very high. It must therefore always be evaluated in conjunction with the filter cumulative efficiency , otherwise it will cause confusion. See also dirt holding capacity

transmission based on a combination of a pump and motor with adjustable geometric displacement. This ensures the highest rotation speed range is achieved with a good level of utilisation ( Figure P 16 ). The

Low-pressure circuit in a hydrostatic transmission with the task of constantly replacing the small oil volume with fresh oil in a closed circuit. For this purpose, there is a feed circuit from the Charge

is a machine for conveying fluids in accordance with the Positive displacement principle . In principle it consists of three components: a housing with inlet and outlet and two gear wheels. Of these, one

Controls which link signals with each other using logic by means of contactors and relays — fitted with contacts. These days, contact controls only tend to be used for small-scale controls, i.e. those

Pressure and flow valves with digital adjustment of the pressure and the flow rate by digital cylinders or by electrical stepper motors. While only a limited number of steps are allowed with cylinder actuation