Objet de la recherche «*».

Used as flat and round seals . In order to provide a tight seal, they must undergo plastic deformation, which enables them to fill up any surface roughness . This is why they can only provide a tight

Branch of hydraulics . Concerned with the generation and transmission of energy and signals via the static pressure associated with a fluid. This is why, compared with hydrokinetics , the pressure ran

Feedback of the pressure for the purpose of stabilising a . In general this feedback operates as a secondary loop.

Preload on seals

Check valve that can also be opened against the locking direction if required. This action occurs via a control piston (K 2) that is dimensioned so that it can open the valve cone against the system p

To make elastic seals actually seal they are deformed on installation such that radial forces, the so-called preload , are produced that make it impossible for the hydraulic fluid to flow around the s

Range within which the disturbance variable can lie, without jeopardising the functionality of the control or (DIN 19 226).

The flow coefficient α is a proportionality factor for the calculation of the flow rate through flow resistances, for example the following applies for orifice-shaped resistances with A = geometricall

The closed end of a cylinder . It can house the rear end position damping and/ or the mounting of the cylinder.

Valves with a large nominal width (generally greater than the nominal size 16 or sometimes at nominal size 10 or nominal size 6) and therefore with large actuation forces are pilot-controlled by a sma