Objet de la recherche «with».

(Controller Area Network) is one of the classic field buses. It connects the individual participants with each other in a control structure. It has been on the market since 1986 and is therefore a proven [...] known protocols relevant for mobile machinery are CANopen, J1939 and ISOBUS. By using the CAN bus with its two-wire cable, time and weight can be saved during installation and commissioning. The number

deflects the beam from a cathode ray tube (Braun tube) in proportion to the input signal and time. With a cathode ray oscilloscope, it is possible to represent things on the screen, set things down on paper

protection for elastomers, which are liable to become scratched, very strict regulations are laid down with regard to surface roughness: For the purpose of sealing non-moving surfaces, an R a of 0.5 to 1.5

important here to separate out solids in the tank or in the filters before they are drawn in again with the fluid. Dispergent oils.

therefore particularly well suited to controlled subsystems that are hard to stabilise or subsystems with a low natural damping, as it generates sufficient damping at higher loop gains . The state controller

Construction type of displacement pumps with multiple pistons, which, as in the radial piston pump, are arranged in a star shape around and perpendicular to the drive axis. They can be subjected to pressure

liquid friction, μ = 0.1 to 0.2. Mixed friction is characterised by the simultaneous presence of areas with lubricating film and touching solids, which causes a frictional force that decreases as relative speed

which in turn is supported by the drive motor (e.g. combustion engine), making it possible to brake with a closed circuit. No valves are necessary in the power flow to control the motor. Alternative: open

The communication is co-ordinated by serial protocols (software) that ensure signal transmission with the correct timing, a high level of immunity to interference and flexibility in relation to the number

the pressure p of the transfer medium on the piston area A K (the most common form of a cylinder): With this approach, forces from just a few N up to 300,000 kN can be applied by a single cylinder during