Objet de la recherche «*».

Filter whose task is to filter out oil droplets from compressed air. They are installed in the compressor group behind the recooler and contain a specific filter element ( Figure O 3 ).

Minimum current needed to flow in an electrical load circuit (e.g. in a solenoid or another electro-mechanical signal converter) in order for a valve to be held in the closed position by the electro-m

Inductive sensors are the favoured choice for short lengths in fluids-based drive technology. These are passive sensors based on the principle of self-induction. If an alternating current flows throug

Time that a variable pump requires to adjust from the max. flow rate Q max to a flow rate of zero. In general this time is shorter than the on-stroke time .

Lasting pressure reduction as a consequence of energy conversion (e.g. at a flow resistance ) (DIN 24 312). The pressure loss along with the leakage loss is the most important source of loss in hydrau

Ratio of the magnitude of the signal considered to the magnitude of the nominal signal (max. signal). For the stability of a closed loop control system (e.g. closed loop position control system ) the

Device used to control or the output of the fluid by influencing the start, stop and direction, as well as the pressure and/or flow rate of the pressure fluid acting in the system ( Figure V 3 ). Valv

Filter with screen fabric as an active filter element. Screen filters are made for a filtration grade up to a maximum of 25 μm, as the ratio of filter surface to free pore space is too unfavourable be

There are two possible methods available for enabling a (relatively) low-pressure circulation of the pump delivery flow if it is needed elsewhere (excluding turning off the drive motor): The three-way