Objet de la recherche «with».

Aromatic or paraffinic hydrocarbons in which certain hydrogen atoms are replaced with chlorine. Low flammability is achieved here by means of chlorine (CETOP RP 100). Certain chlorinated hydrocarbons belong

A control for signal processing that operates predominantly with binary signals in which the binary signals are not an element of the numerical information displayed. The binary control predominantly processes

Hydraulic power pack, consisting of a hydraulic pump and a large Filter with a fineness of 10 or 25 μm, which is used in the main flow to remove the built-up dirt in a hydraulic system before it is actually

value of a physical variable — the measured variable — by means of an indirect or direct comparison with a known reference variable. Measuring requires a master reference element and a device for reading

As far as hydrostatic transmissions with an internal power split are concerned, the input torque from the drive motor is fed through the transmission using mechanical means only, while hydraulic torque

Hydraulic motor with a larger number of displacement units , which are pooled into two or three groups and can be switched in order to achieve different displacement and therefore different speeds. The

method for oscillations based on the removal of energy by throttling, leakage (bypass) or also friction with the special feature that it can only be activated if oscillations occur. The steady-state system behaviour

out the air can then flow in again unhindered. This means a damping seal should have the action of a with a defined leakage.

Motor in connection with a clock as a pilot actuation such that the motor follows the steps exactly. There have even been hydraulic stepper motors, in which a body of rotation controlled by a solenoid

Directional valve with a second tank connection. This design was very popular for a long time, as on the one hand it was possible to place different loads on the two connections and on the other hand special