Objet de la recherche «*».

Control used to interface a numerical control to the machine tool. It e.g. Converts and amplifies the signals that are exchanged between the numerical control and the machine tool, provides Logical op

The analogue computer represents the problem to be solved as analogue physical variables, e.g. as lengths, resistances among others; the problem as a whole is represented here. Analogue computers are

Cylinder in which the fluid pressure for the forward stroke only acts in one and the same direction ( ISO 1219-1 ). The piston can be returned by a spring, the inherent weight of the piston or externa

Different possible ways of accessing registers and memory in the instruction set for a microcomputer. Such possible ways can be: implicit, absolute, indirect, relative etc.

Discontinuously operating elements that measure the input signal at defined times (period pattern) and transmit the values as a sequence of individual signals. A holding element after the sampler reta

Controller that automatically adapts to a changing controlled system. It is intended to ensure constant dynamic performance with a changing controlled system. For this purpose the microcomputer requir

Seated valve

Springs, in which the proportional relationship between the deformation path and the force produced is used for a force comparison in hydraulic controls. A balance is sought between a compressive forc

Variable pump on which the geometric displacement can be set (limited) to a specific flow rate . This setting is made, e.g., by means of a stop screw that fixes the pivoting of the cylinder drum to a

Vessel for collecting and to some extent conditioning hydraulic fluid (removal of contamination and air, quietening). Is used at the same time to remove dissipated heat , however it is only suitable f