Objet de la recherche «*».

Design of the necessary form of control edges in hydraulic valves necessary for the respectively desired manner of influencing the flow rate ( fine control ).

Filter cumulative efficiency

Hydraulic valve which creates the difference between the setpoint and actual value and also releases a flow rate proportional to the difference. To this end, the control unit for the valve is connecte

If the operating conditions during direct actuation become too unfavourable (e.g. due to excessive pressure , excessive flow rate ), indirect actuation will be chosen, which generally uses a smaller d

Hydraulic accumulator on which a spring is used for the pressure load. This solution is only suitable for very small accumulators, as otherwise the spring and therefore the overall dimensions will be

Pressure at the point at which the flushing current leaves the flushed circuit ( feed circuit ) (DIN 24 312).

Hydraulic accumulator manufactured from a combination of steel and plastic to save weight. Suitable for use in vehicles, particularly with a view to energy recovery through braking.

Range in which the "pressure" output signal at a given inlet pressure is controlled by a continuously adjustable valve (E DIN 24 311).

Flow division

Ring-shaped (loop) hydraulic fluid line to supply multiple consumers. Compared with a stub line, the loop line enables: a balanced supply of pressure, i.e. there are smaller pressure fluctuations and